Topics Map > SANDI (Old) - Go to KB-VTH
Topics Map > VADDS & Q-Pulse
Topics Map > Printer Information
Topics Map > Vetstar (Old) - Go to KB-VTH > General: Errors and Issues
Topics Map > Vetstar (Old) - Go to KB-VTH > Printer Setup & Issues

Zebra GX420t Label Printer Skipping Labels

Perform these steps to calibrate the printer and return printing to normal.

  1. Make sure labels are loaded.
  2. Turn on the printer power.
  3. Press and hold the Feed button until the green status light flashes once, then twice and then continuing until the flash groups reach the group of seven flashes. 
  4. Release the Feed button
  • The printer will set the media sensor for the label. 
  • After it is done making this adjustment, the roll will automatically feed until a label is positioned at the print-head.  
  • A profile of the media sensor settings  will print. 
  • Upon completion, the printer will save the new settings in memory and the printer is ready for normal operation.
5. Press the Feed button. One entire blank label will feed. 
6. Log into SANDI and test

Keywords:zebra, gx42, label, skip, every other, every three, printing, skipping, skip subsequent pages   Doc ID:88172
Owner:Jeff F.Group:University of Illinois College of Veterinary Medicine
Created:2018-12-04 10:47 CDTUpdated:2022-09-08 08:50 CDT
Sites:University of Illinois College of Veterinary Medicine
Feedback:  42   38